TRIM-LOKRubber Edge Trim – Fits 1/16” Edge, 1/2” Leg Length, 25’ Length, Black – Flexible Neoprene Edge Protector for Sharp/Rough Surfaces, Easy to Install for Cars, Boats, Machinery and More

I have a fiberglass cap for my 2002 Chevy Tracker - and it would rub the steel and squeak a lot. Put this rubber channel on the fiberglass edge and all is well now. Perfect inexpensive solutions, that should have been on the cap in the first place.

I used this product as a topper for a galvanized steel planter. It is absolutely perfect in that application. Went on easily, stays in place, looks great. I assume it will hold up will over time but I'll come back and comment if that's not the case.Deducting a star because it's really quite pricey. I hope that the product's quality and longevity will prove the value.

Easy to work with....but you may want to straighten it out in the sun if you need it straight though it will lay well with glue. I used it on a .120 alum. panels and it fit great. I ran a slight bead of 3M Super Weatherstrip and Gasket Adhesive on the Alum and it bonded very well. Had to trim slightly the tight radius corners. It was worth it to buy more than I needed right now, as I can see plenty of uses in the future.

wanted it for trim on my boat edging under bin compartments, not wide enough to hold

Worked great for sealing the windows and lights on a couple cnc lathes. No adhesive needed.

Excellent product, good quality and easy to work with. I used it seal the edges of my bumper so that the grilles would not damage the paint, and to help keep water and debris from getting trapped where the grilles meet the bumper. It cuts easily with a razorblade, and is flexible enough to wrap around tight rounded corners. Would definately recommend this versatile product!

Excellent cover for sheet metal. Need adhesive to stay attached.

I used this trim on the sharp cut edge of a piece of metal roofing that was close enough to the ground that I was concerned people would touch it and cut themselves. It did the trick and has not come off yet

Exactement ce que je cherchais pour mes fender flare oem de 2002 gmc sierra. Sa fait tellememt beau dessus et franchement plus beau que d'autre produit qu'on peut mettre. Caoutchouc très souple car mes fender flares font un angle de 90° et le caoutchouc suit l'angle sans problème. Merci beaucoup Amazon

This rubber molding is refined in appearance and exactly what we needed for our application. The polycarbonate in our application is 1/16" thick. This molding will grip onto an edge that is not subject to being struck where the open edges of molding are on the surface of the material it is pushed onto. In our application, the open edge of the molding was being struck from time to time pushing it off the material it was pushed onto. We addressed this by bending 10 mm wide 3M 300LSE two sided tape (purchased off Amazon) around the edge of the polycarbonate. We then peeled off the backing and pushed the rubber molding onto the edge. The rubber molding is now on the edge of the polycarbonate FOREVER!!!

Suited my purpose

I put over sharp edges of very thin 1/4 inch wire mesh called hardware cloth; it fits snug and secure.

The length was more like 20ft instead of 25ft. Left well short for my project. Not worth the $60.