Energy Suspension 9.5161G 1" Greasable Sway Bar Set , Black

Worked on my 1984 Ford mustang. Good quality and easy install.

It greatly improves the road feel in the steering wheel. The front end is firmer and more planted with less lean when turning fast or making quick maneuvers. My 1997 Grand marquis feels so much better and is much more enjoyable to drive now.

Fit well. Worked well

I made the mistake of installing a new rear sway bar on my MK7 GTI with the standard plastic bushings. After several months, and into the winter, they started squeaking like crazy. I was so happy to learn about these replacement, greasable bushings! They took me about an hour under the car to swap out. Not the easiest or cleanest job, but easily doable with a socket set and the correct triple square head for the bolts. I also bought a grease gun and some all purpose grease. The design in the bushings has grooves to hopefully keep the grease in place and quiet for a long time. I anticipate I'll have to grease these somewhat regularly, but at least that's an option now. So far, I'm really pleased, especially for the cost!

Bushings and brackets are good quality. but one of the zerk fitting caps were split upon arrival so i cant cap it off. Not going to return it to replace a cheap plastic cap but had to spend another $13 for a 25 pack of caps ( smallest option available on amazon).

Exactly what I needed!

My original rubber sway bar bushings were worn out and left me with a clunk in the front end so I replaced my sway bar bushings with regular polyurethane bushings. This worked fine for a month or two before the supplied grease the polyurethane bushings comes with wears out. Then the squeaking begins. Every bump. Every dip. WD40 and other lubricants work to quiet the noise for a while but not for long so I went with greasable polyurethane bushings. Installation is easy since the bushings are split to fit over the sway bar without removing it. I packed the bushings with grease before installing them and pumped a few shots of grease into them after installation until it oozed out the sides. Now, when I grease my front end I also grease my sway bar bushings and no more clunks or squeaks. I use the same grease I use for the front end. I know they make special grease for polyurethane bushings but I have not found any problems using a quality standard grease.

There is nothing worse than a squeaking rear end suspension and my other bushings on the cheap 1" sway bar were junk when I got them. I installed these and greased them with a grease gun when I got them, and they been perfect. No squeaking. No clunking. I didn't know that was possible. Should have bought these a long time ago.