Milwaukee 48-66-0061 1/2-Inch Square Female to 7/16-Inch Hex Female Adapter

Seems good so far. I’ve used it about 20 times and haven’t held back at all. It’s an adapter tho, and like all adapters, it’s bound to fail at some point. 5 stars because it seems to be holding up so far, and for $30-ish, when it does fail, it’s cheap enough to replace.

Worked well

Simple review, if you have a 1/2 inch cordless impact gun you need this item. Even if you never thought of using an impact to run ship auger bits this makes boring holes so much easier than a drill. If the bit binds an impact will not try to break your wrist, throw you off the ladder, etc....

Works as intended. I purchased it to use on my Milwaukee 1/2" impact for large 1" drill bit. Its holding up fine to the 600 or so foot pounds of torque that impact puts out.The reason I can not give it 5 stars is as others have said, it does not lock onto the driver extremely snugly. Maybe 1 in 4 times I drill through a stud it pops off the drill

I can hardly do without this tool after using it for a few months. Aerial framing transmission poles used to mean taking the huge gas drill or Super Hog with an extension cord to the top of a 90 plus foot pole. Now I can punch a 15/16 hole through a pole with the same rattle gun I use for everything else saving a lot of room in the bucket. Word to the wise, it can be a pain if you don't have a detent pin on your rattle gun. If you plan to use this avoid hog rings.

The tip kept coming off .had to tape it on drill.

This product works like a charm. We work on powerlines and it holds up to our work. Great deal guys.

Got what was shown and it was everything it needed to be.. will be used alot.