LABEAR- Drill Chuck Keyless Mini 3-Jaw Adapter with Quick-change 1/4" Hex Shank to Hold 1.5-6mm Alloy Black Drill Bits Milling Cutters

These LaBear chucks are actual steel. After having purchased some others that turned out to be aluminum and also wobbled the bit in my press, I tried out LaBear (two on the left). Drill bit wobble immediately went away, and I’m able to sufficiently tighten it without stripping the casing. All the chucks were around the same price, which surprises me now that I’ve held both, and can instantly feel the heavier and more durable build of the LaBear adapters. The teeth of the LaBear chuck are also much better (still pictured on the left) coming to an even close point without too much chamfering creating a large gap making it hard to clamp those small drill bits. These definitely feel like the premium grade I was hoping to get, just still surprised by the price!

Works great in my DCD985. When you open it wide the interior springs look like they could be easily damaged if you weren't very well aligned with your bit installation, but those should be few and far apart with how affordable these are. They held a 3/16 bit comfortably through wood, even in a quick-change shank socket. The bit didn't slip at all in use.

Fine for for the price. I've found I have to re-tighten the chuck once or twice during each use, especially with smaller bits.

Perfect addition for hand drill or bench press when the chuck can’t grab micro drill bits. Works great would definitely buy again

So far it has work great, no problems noted.

Did not hold drills well, fell apart when opening fully, poor design. Cheap......

Nice little chuck. Runs very true if you hold it in a drill press. Don't expect it to run true if you use it in a 1/4” hex drive tool. The tolerance of both the drill and the chuck aren't good enough for the drill bit to have no runout.

Bueno