ARRIS 200 X 300 X 3MM Carbon Fiber Sheet, Available in 0.5MM 1.0MM 1.5MM 2.0MM 2.5MM 3.5MM 4.0MM 4.5MM 5MM 6MM 100% 3K Carbon Fiber Plate Twill Matte

I bought this carbon fiber sheet for a custom project, and I’m seriously impressed. The weave is clean and consistent, and the surface finish has that classic carbon fiber look, sleek and professional. It’s lightweight but surprisingly strong, just what I needed for both structure and aesthetics.

It worked out great! I went with 3.5mm thickness for my dash panel. I'm a sucker for that carbon fiber look.

I bought these to replace a few dash panels for a show car and the size has me taken care of, I had more then I though I needed. Quality build, I had a hard time getting these things to cut down to fit in the car but I managed. Definitely will buy again for the next project best value for your money people!

This is a nice quality product!

I bought this to make body mounts and electronics tray for an rc crawler. Quality seems pretty high, nice and easy to work with, definitely durable so far for what I've used it for. I have painted the pieces I've made so don't expect it to be colored.

I'm using this as a print surface and the quality of this piece is amazing. The surface is smooth as glass, but is more of a satin finish on it. It's a perfect 300x300mm dimensionally and its flatness is better than my PEI spring steel sheet.

Looks good, feels great, nice even layers. For straight cuts I HIGHLY recommend using a tile saw with continuous rim diamond blade. I bought the cheapest I could find, & used the continuous rim diamond blade that came with it, & got flawless straight cuts!!! You can even do some minor shaping using the side of the blade i.e. knocking off sharp corners. Just be sure you keep plenty of water for zero dust.Purchased the 2.5mm plate, it's extremely stiff, like 1/8" 304 stainless steel plate stiff, just a hair over the length & width, but not quite 2.5mm thick. I had one cut-off piece that was 1.5mm wide, I bent it 60 degrees and it still did not crack or break!I measured in 20 different places along the outer edge, average thickness was just 0.0947" (2.405mm) with the minimum being 0.0902" (2.29mm), and maximum being 0.0978"(2.484mm) .... 2.5mm is 0.0984252" so even the thickest point did not measure 2.5mm. Length & width are 11.8193" x 11.8334" or 300.21mm x 300.57mmPurchased to make a custom battery box for LiFePO4 12.8v battery I'm building. This will be the outer box with 1.5mm fiberglass plates between each cell.Unrelated to the project the plate was purchased for... the plate has a very musical quality to it. I might try to make a mini-wind chime out of the scraps!!!******EDIT 3-1-2024: added two new photos of my cut on the tile saw. ******

Arris always holds its qualities. Reliable and great materials