Superior Graphic Supplies 30 Mil Magnetic White Sheet Roll – 24" x 30", Heavy Duty Flexible Magnetic Film – Matte White Finish, DIY Craft Magnet Tape, Gifts, Car Doors and More

It works great on my table saw, jointer, and drill press. It keeps everything clean and rust free.

It was exactly as advertised. I am very pleased.

I used this to make a magnet board for my craft room. My husband framed it and put it on the wall for all my die that I use for crafting! Excellent and will definitely buy again!

This is a material which one can buy in any quantity, and the more you buy, the cheaper it [should] be. So I bought more than I needed and will have it later.The white surface appears to accept 3m spray adhesive well, and the white layer and magnetic layer didn't immediately delaminate when I went at some small angles cutting with an exacto blade. And the resulting piece sticks acceptably to a butter knife or refrigerator. No reason to expect that it wouldn't hold well on a larger surface.Haven't seen it after time in the sun, or the cold.

This was a complete waste of money. The magnetic field on this stuff is a joke. So weak that it almost cannot overcome the force from the residual curvature left in this material from being shipped in a roll. If the steel surface on which you place this has any openings, like the louvers on a cold-air return, or an opening on a cabinet saw, there is not enough magnetic strength in this material to adhere.Only buy this stuff if you’re putting it on an almost-flat and completely continuous surface - no holes or openings allowed, or it will not adhere at all. Not even strong enough to make refrigerator magnets.Terrible.

We rented a house in a gated community because we were working out of town. Our vehicle has a company logo that we had to cover up. These are perfect for cover up out door panels. The material is thick and durable, and has lasted through a few rainstorms so far.

Product worked great. I’ve ordered a couple rolls now. I was able to easily cut them down to different sizes with a utility knife and metal straight edge. I’ve used the material to protect the cast iron top of tools from moisture to prevent rust and damage. I also used some to place over vents on gas direct vent fireplace to block drafts when the fireplace isn’t in use.The left over scraps have also been useful for kids crafts.

Love this product, it works great for what I need it for!!