Sound Storm EV2.2000 Evolution 2000 Watt, 2 Channel, 2 to 8 Ohm Stable Class A/B, Full Range, Bridgeable, MOSFET Car Amplifier with Remote Subwoofer Control

Installed this in my 2006 Nissan Frontier 4x4. Added an under the rear seat Audio Enhancer 10" sub box with a Rockford Fosgate R2 shallow mount sub. The sub is a DVC 2 ohm, so ran it in series for a 4 ohm load and then wired the amp bridged mono. I really like the sub volume knob, ran that up front under the dash. This is more than enough for this little truck and I'm not joining any sound comps or SPL comps either. Sounds great with my ATOTO A6PF headunit, Pioneer TS-692C 2-way components upfront and TS-A1680 in the rear with 85Hz and 200Hz blockers on the fronts/rears. This my 2nd SSL amp, I have an EVO1500.1 running a Rockford Fosgate P2D4 12" in my car and it is more than enough for that sub. Great value, great features, zero issues.

I have bought a lot of very expensive amps that arent built as well as this one, specially for the price. All the connections are well laid out, all the controls are easily adjusted, the body is well built and very clean looking. The manual is very well written and easily understood with a lot more info than a lot of higher priced models. I have been running this amp bridged at 2 Ohms for a week now, it has performed flawlessly without overheating even once, I have it mounted in a pretty tight area that doesnt get much air circulation, in fact I had an MTX amp mounted in the same spot and it would constantly overheat and go into protection. As far as sound quality goes it sounds very good! No noise, very clean and solid bass, I am able to play it far louder than the MTX and Rockford Fosgate it replaced, it actually sounds like it was made to listen to not just to make speakers go boom. I listen to music not Rap and it sounds very smooth no matter what I play. Drums sound like drums, bass guitars sound like guitars not like a horrible low frequency buzz. I was so happy with the quality that I bought a SSL EV4.400 four channel amp for my mids and tweets, I also bought a SSL S4EQ to control everything. If these units last a month with the punishment I give them I will be buying more SSL products. It's nice to know someone makes a quality amp that doesnt cost a fortune! I wouldnt hesitate to recomend this amp to anyone looking for a quality product at a very good price!

This amp has a very nice look to it. It is constructed of mainly aluminum with a really nice looking finish. It has a lot of controls on it including high and low pass filters, bass boost, and gain control. It also includes a remote gain control that you can mount in the front of your car for quick and easy control of the gain. The features of this amp are comparable of much higher-priced amps, and seems very professional. I first connected this amp in bridged mode to two 250w RMS subs, and I was very disappointed with its performance. I tried changing the gain and bass boost, but I couldn't get the subs to hit hard without the amp going into protection mode (the internal circuit cuts off and will reset once you turn the amp off and back on). The sound quality was great, but the amp wasn't pushing much power at all. The amp is rated for 1000w at 4ohms when in bridged mode, and it was not going anywhere close to that. After reading a few reviews online I decided to hook the two subs up in stereo mode instead of bridged. After doing this I have yet to get the amp to go into protection mode! It does not push as much power as it did in bridged mode, but it sounds great and can get very loud! The sound quality of this amp is very close to amps that cost more than 2x its price. I really recommend this amp, but take into consideration that I could not get it to work well in bridged mode.

Great amp for the price. After my Pioneer sh*t out on me, I shopped around the internet for amplifiers that would rattle my windows but not break the bank. This one fit the bill perfectly. Tons of adjustment options, clear and precise bass, simple setup (took me about 10 minutes, with my wiring kit already installed) and it looks beautiful. The power LED indicator is really bright, but I guess that can be a good thing. It doesn't draw heavily on your electrical system, either. My old amp used to make my lights dim and RPMs fluctuate and that kind of thing, but this one is a higher wattage and draws almost nothing out of my electrical system. Highly recommend, it's worth it. My bass control knob works with my amp, but I already had one installed so I'm leaving the SSL one off for now. THIS AMP STAYS COOL. I've had it pounding non-stop for a three hour road trip on several occasions, and it never once heated up on me. Just make sure it can breathe, it is vented on the bottom so I would recommend mounting it to something to allow airflow underneath it. I used just a small piece of wood to prop one end up about an inch, and that's plenty.

I bought two of these "1200W" amps. They look outstanding, have a lot of very nice features, and push a decent amount of power...especially when you consider the LOW price. But, and it's a fairly BIG BUT, do not buy this expecting to get ANYWHERE NEAR 1200W out of it!! First, they advertise as "2 ohm stereo stable", & yeah it is (doesn't go into protected mode & shut off when you run it at 2 ohm STEREO, but don't even think of 2 ohm bridged), but it puts out I would say MORE clean power into 4 ohms than 2!!! And it does not have a "soft turn on/off" so you can expect that wonderful POP when you power it on/off. Decent overall for the price...just don't expect too much!!!

Bought this to build a bedroll speaker for my 2005 Harley. It works perfect, I only have 2 6.5" kicker marine speakers wired to it currently with a bluetooth adapter to my phone.

As described and pounds good driving 2 12" clarion competition subs...works great so far.

I installed it in my truck and it sounds great.

Excellent amp. Clear sounds, no distortion. I'm using it for a subwoofer, but it has the ability to be used for full range speakers as well, which I'm tempted to try. I'm using this to power a previously-passive home theater 110 Watt subwoofer, and it works great. It could definitely push more than that if need be, as on the 100mV- 2V setting and maximum source volume, it only needs a quarter turn on the gain to operate. I'm using it paired with a 200 Watt DC power supply that I also bought on here. Only downside, and not worth even losing a star over, is the fact that even with the HPF on, you can still hear some high level noises slightly. Only reason I notice is that I have the ability to turn off all other speakers. Normally, it wouldn't matter. If I ever have the need for a subwoofer or 2 channel amp, this is my new go-to. You can easily use it in a home-theater setup as well, with the addition of a 12Vdc power supply for around CAD$20.

Like how small and clean sound

Powers my 400w rms Pioneer 12" perfectly, and i like lots of bass. Gain is set to just over half and boost set to just under half. Check both sensitivity settings before freaking when there's no sound. Very happy with this amp and the remote level control is a great feature. Mounted discreetly and conveniently under the steering wheel for quick level control. Price on point.