BehringerNX1000D Power Amplifier with DSP

PRODUCT WAS DELIVERED AS SCHEDULED. iT WAS FREE OF SHIPPING DEFECTS.

Perfect

Manuals are useless... customer support impossible to reach, forced you through a questionnaire, new accounts, etc... cannot talk to someone live. Website takes 10 seconds to load for each click.Bought 3 units, all of them refuses to output signal using channel A.Absolutely, terrible experience.

Buy this with a noctua 1200 RPM+ 80mm fan and just know right off the bat you are going to open it up and replace the fan. You may need to solder or just use the old connector. That solves the fan noise right away. You could in theory also put a 120mm fan on the top, but it felt like overkill considering the heat this actually generates and you'd lose the ability to stack.Next up make sure you have a type A USB cable so you can hook it up to a PC and use the DSP controls.Know it isn't going to push the watts that it says here. at 8ohms, like 72w per channel. at 4 ohms 170w.Quite a few negatives I know. I'm using this amp on a car subwoofer for my desktop. I'm using the bridged mode (you need a 4 pole/cable speakon cable - I made my own). It does a fantastic job on the subwoofer and the DSP on a desktop is kind of awesome. So I may be only pulling ~350w but that's plenty on my desktop application and keeps things nice and cool since it's a class D amp.

I'm not certain if I had a defective unit, but when on it sounded like I had a jet turbine engine in my living room. If you're not concerned with excessive noise then this is arguably the best bang for the watt.