Procomm Magnetic Mic Holder

The magnet is weak, but for those who say the clip is loose and won't hold their mic, literally all you have to do is make the bend a little tighter, I did it by pressing the holder by hand, clip down, on a hard surface. I think most 5-year-olds could figure that one out.

This item was pretty good. The only issue I had with it is the section where the mic goes into the piece isn't tight enough to hold the mic on its own. I had to put a little bit of gorilla glue inside of it and allow it to dry before I could use it. The mic will slide off of the mic holder unless you glue it in. But I got it to work and it does what its suppose to now. The magnet is powerful enough to hold the mic on the roof of my truck when it was raining and blowing wind realllly hard.

works good but magnet is rather weak. I have an old one from years ago and the magnet on it is much stronger.

The metal is well pressed but the magnets are so weak that that that they come with 2 sided adhesive tape. If you expect these to stay in place in actual use be prepared to glue them there. Very disappointing.

These work as designed. seem to work well and are rugged for what I need. You do need a flat metal surface to stick them on.

A little hard to keep secure but I just used a rubber band to attach it to my mic works fine!!

Magnet is not very strong. Can't even hold the microphone up. Would not buy again.

Came on time and works well