HolyBro Kakute V2 - Tekko32 4-in-1 ESC Combo FPV Drone Racing

Description

Holybro is saving you time and guesswork into making your perfect FPV stack. Comes with the Kakute V2 FC, and the Tekko32 4-in-1 ESC. This is the stack found in the Holybro Kopis 1 Racing Drone. Just add a video transmitter such as the Lumenier TX5GS and you're set! Tekko32 35A 4-in-1 ESCFeatures4-in-1 ESC with 30.5x30.5mm mounting holes, supports DSHOT 1200, BLHELI32 firmwareAdded more CAPS to reduce power noise32bit ESC with BLHELI32 firmware4PWM inputVoltage output (VBAT), ESC Telemetry(TELEM)Supports Oneshot / Multishot / Dshot PWMSupports damped lightNO BECSpecificationsSupports 3-6S lipo input35A continuous current, 50A burstMounting holes 30.5x30.5mmSize: 55*40*6.4mmWeight: 17gKakute F4 V2New V2 FeaturesTwo extra UART PortsUART4 port for serial camera like the runcam split. (This is not the same as Betaflight Camera Control, which runs of the OSD menu for cameras like the swift, monster).UART5 port for ESC telemetry support (for BLheli32 and KISS)Through-hole solder pads instead of flat pads for more secure soldering especially for beginners.Barometer sensor on board allows altitude hold mode.Dedicated I2C pads to connect extra peripherals (like an external compass)FeaturesSupports Betaflight and Cleanflight.Betaflight OSD. Change PIDs, adjust common configuration parameters, and change video transmitter channel and power level, all using your transmitter sticks and goggles.Soft-mounting built in. The IMU ("gyro") chip on this board is mounted on vibration-isolating foam. This means that there is no need to soft-mount the board itself.New high-performance / low-noise / high sensitivity IMU. ICM20689 with 6-axis gyro and accelerometer. Can run at up to 32 kHz.2 oz. copper PCB allows