Ibywind Screen Protector For Oneplus 11 5G(6.7 Inches),with 2Pcs Flexible TPU Film,1Pc Camera Lens Protector,1Pc Backing Carbon Fiber Film [Fingerprint Reader,Easy to install]

Was a bit nervous about ordering this screen protector. None of the big screen protector brands make them for the OnePlus 11. All I can say is never judge a book by the cover. The screen protector is super easy to apply once you get to grips with the instructions, and it comes with a plastic bracket that slots into the type c port and holds the bottom of the screen protector while you're lining it up correctly. It covers enough of the screen to not notice there's a screen protector applied yet it doesn't cover so much that it would peel off with the use of a phone case. The fingerprint sensor still works flawlessly after application and the front camera has its own cutout so front camera quality won't be affected. The camera protector that was supplied was a bit more tricky, it takes a bit of skill and guesswork to apply it perfectly. I managed to do it just about perfectly. The 2 cameras on the left of the camera area are where the 2 slightly bigger cutouts should go. If you don't place it down perfectly first try, you can easily pick it off and try again as I'm assuming the adhesive takes a few minutes to fully set on the glass. I've never seen a camera lens assembly so big on a phone so the camera protector is a must-have to protect against scratches in your pocket. Update: I've had this product applied to my phone for more than half a year now. The camera protector is stuck down absolutely solid. Once the adhesive has had time to set, there is no way that thing is gonna fall off in your pocket. One thing I must say though, is the edges of the camera protector have gathered dust over time so IPA and cotton swabs are needed to clean up the area and get it looking good again. As for the actual screen protector, I've noticed some people are saying it peels up at the edges with the use of a case. I've never had that happen to me and I've had about 6 cases on my phone since I've owned it. I think just extra care is required to make sure it's aligned absolutely perfect. The use of an adjustable desk lamp can be very helpful in this situation. Also, the screen protector does feel rough for the first few days but it smooths itself through normal use. In the original review, I forgot to mention the carbon fiber skin that's supplied for the back of the phone. Applying that thing requires way too much skill. I tried applying it and could not get it perfectly aligned no matter how many times I peeled it and tried again so I threw it in the bin.

wowwwww this is the best item purchase for a long time . excellent quality easy to put on and all the tools for perfect finish - best best

I don't really write reviews and I'm not a paid review or a bot. But I was really impressed with this screen protector. It is very easy to use despite others saying its not. Out of all the tpu film screen protectors I've used, this was by far the easiest to install. I had no bubbles lest 1 that was a spec I didn't manage to pick up. It goes around the edge very well. I've had on a for a week and I haven't had any peeling on corners etc. The main thing I was pleased with was the clarity of the film. Previous tpu films or self healing ones I have used were absolutely awful. They caused distortion on the screen and like lumpy lines. The previous ones also were not smooth to glide the finger. This one really is clear and gliding finger across the screen feels very much like the glass it self. Good for gaming I suppose. Oh well. It's been a week. If it lasts me or fails on me I will try to update. Edit : OK so months on and this is by far the best I've used. I'm an electrician so I have lots of issues with glass protectors scratching and chipping. I have exchanged this on my screen twice now (due to my own fault. Tools and screws in pocket). It's always easy to put on. It leaves no bubbles and most of all it doesn't peel away due to the case. Buy with confidence.

Edit: As feared, the film eventually bubbled badly at the edge. The second one did the same, not even lasting a month. The good news is that this is the first screen protector I've installed that aligned perfectly and had zero bubbles. That would get it five stars, but the film itself has a soft/tacky feel to it which isn't the best. It has also bubbled up on one corner a few times and, although I've been able to stick it down again, I don't know how long I'll be able to do this if the bubbling continues.

This is a great product for my phone screen. It comes with a set of really useful toolkit for installing it. It works very well, allows fingerprint reading, etc. but only one but, it doesn't last long. I have had to replace two already in less than two years. Might just be me and the way I use the phone....

PROTIP: run a hot shower and then fit your protector in the bathroom, the steam will eliminate dust in the air and get you better results 😉 Bought for my OnePlus 11 after the factory one came off and the cheapie ones I bought on eBay didn't stick to the phone's stupid curved edges. It may look like a generic brand but my gf asked me to fit one of these to her phone and I was pleasantly surprised by the quality so got one for my phone. Happy to report I got great results, perfectly aligned without a single bubble or mark. The little usb-plug guide works great and overall quality is really good. Mm, I've changed cases several times and it's stayed perfect. The little microfibre cloths are really nice and the tpu seems very durable. Fingerprint sensor works 100% (I recommend re-registering your prints but it did work fine without doing that). Only downside is the feel of the screen is a bit...rubbery maybe? Just a great quality pack, actually better than oneplus' factory protector.

I used to always get glass ones which would crack. This one feels great to use, but if you have long nails they won't glide over as good as glass due to the material being a bit softer, small scratches seem to heal themselves. While mine looks as clean as the day I installed it, My wife on the other hand puts phones to the test and the screen protector has some holes in it😂 but the phone glass is safe. She would also get cracks in her glass screen protectors too very quickly so she was happier with this one. Have to say this was very easy to install in the correct position with the plastic guide! The camera protector was useless though, fell off very quickly.

This screen protector is easy to apply and gives good everyday protection—no fuss with bubbles or alignment issues, and it keeps the OnePlus 11’s display clear and safe from scratches. However, after several weeks to a couple of months, the edges start peeling back, which seems to be down to the phone’s curved screen design. I’ve bought two sets and both have gradually had the same issue over time: the middle stays stuck, but the sides eventually lift up and collect dust. It still does a solid job at keeping the main screen safe, and the flexible TPU absorbs knocks well. Just be aware that the edge peeling is a recurring frustration for curved screens like this one. Otherwise, it’s decent for the price—just don’t expect it to be flawless long term.