NEXTIONILI9341 3.2 inch TFT LCD Display Module 320x240 Resistive Touch Screen for Mega-2560 only, not Display from N e x t i o n Series

If you are looking for a 3.2" touch screen for Arduino Mega, then this is what you buy.Just inserting this panel into a suitable shield, then it works.(You may need to set a suitable parameter in Arduino sketches to use this, but it is not a difficult task.)The quality of display is very nice and touch panel response is also good enough.

The Touch Screen cannot be made to work. SO, I decided to just use it as a display. Now comes the really fun part. The seller provides a schematic of the LCD board with ZERO information as to which Arduino pins are to be used. I purchased the recommended shield board and, GUESS WHAT, there is no information available for Arduino pin usage either.If you want a pretty display with no touch capabilities and no ability to interface any other hardware then, this is the product for you! If you want to make something useful with it, no way!

Very easy to use with UTFT and URTouch libraries. Initialize with "UTFT myGLCD(ILI9341_16,38,39,40,41);" and "URTouch myTouch(6, 5, 4, 3, 2);". This screen or maybe the shield it goes with does however have some connection issues as mentioned by other reviews. If it doesn't work just reseat everything over and over, took about 4 or 5 times before it worked for me.

It was a nice bright display. Easy to use.

It's seriously horrible. I'd stay away from this.

The LCD part worked ok, but the point of getting a touch screen was to use that function.If the display board had a Wiring schematic you could then at least trouble shoot, to see ifthe touch screen was hooked up correctly and to then try and remap the pins in theDinky software to hopefully get the touch working. Very, Very, Very disappointed.I was getting this screen type from Sain Smart which all worked GREAT, but they quitcarrying this size. The DIY Mall is the only one I found, and perhaps they buy from thesame manufacturer and quit carrying this when the touch quit working..........Buyer beware, look elsewhere, saw another poster here with the EXACT same touch problem..

I purchased this LCD Touch along with the TFT LCD Mega Shield 2.2 shield for the Arduino Mega also from Amazon. It was easy to figure out getting the UFTF library from Rinky Dink Electronics to work. I used "UTFT myGLCD(CTE32_R2,38,39,40,41);" or "UTFT myGLCD(ILI9341_16,38,39,40,41);" and they both worked. I had a very hard time getting the actual touch function to work. The default of "URTouch myTouch(6, 5, 4, 3, 2);" for the touch library is correct on the Mega. It turned out to be a connection issue. I just reseated the board a couple of times and it worked. I recommend testing this LCD with the examples from the URTouch library. The online examples are too complicated and have too many dependencies to break. Get the basic screen and touch working first. Don't forget to debounce the touch with a short delay. This screen is touchy which makes it fast to enter numbers for me. It worked just powered from my PC with a USB cable to the Arduino Mega. Very Easy.

Worked great as expected bright easy to read