XT60i to O Ring Terminal Cable，More Than 8A，10AWG Extension Cable XT60i Female to O Ring Connector XT60i-f Compatible with Lipo Batterie (1.5M/5FT)

Use with my Ecoflow. I go from 100 watts charging through my cigarette lighter. To 200 watts from the battery. Good gauge wire. No complaints

As promised and it did the trick.

Working great as an interface between my 12v eco-worthy lifepo batteries and my ecoflow delta 2 and 3. If I remember correctly, I get about 200 watts out of each batter at 12v with this cable.

Works well for using LiPo battery to double power station capacity. Has correct, and required, signal wire pre-installed.

Plain and simple everything was as advertised.

I keep these cables connected to my busbars to give my EcoFlow Delta 2 a charge from my house battery bank. Gives me a steady 200w charge rate. Just what I was looking for.

12awg wire insulated at 60C (which this product is) is rated for up to 20A of current. The Delta models from Ecoflow are limited to 15A of current on their XT60 port when using XT60i, so this is a perfect fit! Here you can see it connected to an AOLithium 100ah 12v LiFePO4 Battery which is plugged into our Delta 3.Works great and feels great. The leads leading up to the battery are barely wide enough to reach the terminals, so be careful if you have to split them at the insulation to make them reach. Luckily, I did not have to.

I have a Delta 3 plus and Anker F3800, using 48 volt 100 amp rack batteries the Anker charges at 1100 watts. Delta 500 watts. If needed I can add another cable to double input. The XT60i fits both because the center pin is blank on Anker. Cost of rack batteries are far cheaper, with higher capacity than buying extra batteries. Be careful not to exceed max voltages to not let the magic smoke out