Titebond4 Oz. PVC Trim Joint Adhesive

I had never installed PVC trim before, so I watched some videos and saw this adhesive being used. I gave it a try, and it works exactly as advertised, which is extremely well. Be advised, however, that you will get ONE opportunity for alignment of your parts. As soon as it grabs, it will not let go. I was creating miter joints, and through trial and error I found the best method was to test fit the parts, apply glue, bring the long points together, then bring the two surfaces of the joint into contact and hold it for 20 seconds. At that point, the adhesive had essentially set and I could add a single screw through the joint just in case. Also as advertised, it will bond skin instantly.

Used this on butt joints on PVC trim. The joints are strong, surprisingly so. It doesn't take much. Did the trim on the whole house and didn't finish one bottle. The joints don't harden as quickly as one is led to believe. I used some spray on CA accelerator and that makes them about 10 seconds.Is not for filling gaps. The joints need good fit.Very pleased with the results. Will buy again.

Used this on smaller projects using PVC Board and it works perfectly.

This relatively thin glue allows several minutes of working time once applied, however once the curing process takes place - Nothing is going to move or break apart PVC "Wood" or other similar materials. This Glue is commonly used for products like AZEK - a simulated plastic wood material. It allows full and permanent bonding along long edges to make cases built over pressure treated or other lumber to be absolutely water proof. Certain bonds "board" arrangements become significantly reinforced structurally.Strongly recommend and suggest making sure the joint is not moved for a few hours once in final position. Bond will be permanent in the final configuration.

I glued tow pieced on PVC tri together and one hour later put the in a vise to break them apart. Tje glue joint remained 100% in tact, the PVC broke apart away from the glue joint.I was using another brand that advertised a 10 second working time and bought this one because Titebond claimed it had a 30 second working time. I found the 30 second working time is true if and only if you apply the adhesive to both surfaces. If you apply the adhesive to one surface only, when you combine the two pieces your working time is only about 4 seconds. This is because the second dry piece absorbs the adhesive from the first piece causing it to set as soon as its absorbed. So just wet both sides of the joint you wish to combine and you will lover this product

This works great on pvc trim, but don't get it on anything you don't want permanently glued. I wore latex gloves and they were ripping and sticking to the trim it dried so fast.

Good glue. Works well

Stuff works great bonds fast holds strong