60 x 60 x 25mm

I bought two to help cool an air pump running a diffuser in my pond. Easy to wire with the included connectors. Simple but they do the job with no issues.

I use an intense UV LED light array to cure resin on printed circuit boards and that thing gets HOT! I 3D printed a vented enclosure, added some heat sinks and this fan. Everything runs at a more than acceptable heat range now. The fan pulls a good amount of air and is fairly quiet.

It is .a small fan so I realize that it must be a tough job to pack enough winding to give adequate power. Therefore, the CFM is a bit low. A DC fan the same size I think would be faster, but this fan can do the job I wanted it to do, move some air.

Exactly as advertised.

Purchased for cooling electronics inside a project box. Rather than sacrifice space inside the box by using a much cheaper low voltage fan and using a voltage converter I spent the money on this fan and wired it directly into the 240v power in my project box. It works well and moves a lot of air. The kit has a 110v power cord with switch, 2 safety grills, 4 long mounting bolts with nuts. Powerful fans are inherently noisy and this one is no exception however in addition to typical fan noise there is an extra kind of relatively low frequency noise that doesn’t seem normal (except perhaps in a very old desktop/tower PC) and for sure I would return if my application wasn’t already in a noisy environment and everything already wired together.

Used it to help cool a pond aerator. It's ran for 25 months 24 hours a day and it's just now starting to go out. I'm pleased with it and just ordered a new one

I installed this fan into one of my TV cabinets to keep it's components/electronics cool. It wasn't hard to install this fan. For my cabinet, a 2" hole drill did the trick and was the perfect size to mount this fan to. It's relatively quiet; we cannot hear the fan operating 24/7 while we're in the room. It comes with everything you need, including two grills for protection. Great product!

I understand this is not the intended use for this fan 😆 but this is my worm farm I raise them in old non working deep freezers and they need oxygen to survive I drilled holes in the freezer buy it was not enough to provide enough air so I installed this product inside to pull air through the drilled holes and to circulate cool air from the frozen water bottles inside. This fan has ran constant for 2 months and is working perfectly for the purpose of what I'm using it for. I highly recommend them. Very reliable!!!

لم تصلني المروحه وصلني راديو