BIGTREETECH CB1 Heatsink for CB1 V2.2 Core Board CB1 eMMC V1.1 Control Board Compute Core Board 3D Printer Parts

i printed a louvered cover for my motherboard and this heatsink looks nice and does the job very well dissipating the heat correctly, was an easy install too.

It’s made for the cb1, but I have it on a Pad 7. The position is the same, the board is the same, perfect fit. Definitely needed as the board runs hot.

This heatsink looks great, fits perfectly and comes with everything you need to attached it to the mainboard. All I had to do was attach the included thermal pad and screw it down. The CB modules can get very warm so this is a must!

I have tgis and a raspberrypi 4. This is a GREAT alternative to my raspberrypi, its does just as good. Easy setup and fast. Just fallow the bigtreetech directions and your good to go

The provided screws do not fit the Manta E3EZ board with CB1 V2.2

Buy Buy Buy! CB1 processor board runs hot! This is a must.

It’s holding using gravity plus the thermal pad. Mostly because the BTT Manta E3 EZ I use it with has some non standard mounting holes. Overall, you should use one with any CB1 and that make theys price much more expensive. That’s unfortunate.

In case you were wondering: this does not fit the CB2. The screw holes line up fine, but there are two components on the CB2 board that stick out and do not allow the CB2 heatsink to fit flat on the main chip.