COOSPO Cadence & Speed Sensor for Cycling, Wireless Bluetooth & ANT+ Bike RPM Sensor for Cycling Computers, Compatible with IP67 / Rouvy / Zwift / Peloton / Wahoo / CooSporide

Followup to followup review ---- I reached out to the mfg about the broken ear causing the sensor to fall off, and preventing it from being mounted. After verifying that I mounted it correctly, they quickly send me a replacement. I wrapped the sensor with electrical tape just to be safe. Looking at the sensor after roughly one week, I can see the silicone band snapped under the tape. So there is definitely some weakness with the band, as this is the second one that broke. Followup review ---- On one of my ride, I glanced down and saw my cadence being blank and noticed the sensor not there anymore. I saved and replayed my ride to see where the cadence stopped, rode back 3 miles and found the sensor Turns out the one of the ears where the silicone band hooks onto broke off, just as I had concern about. I went back a couple of days later and found the rubber backing along with a fragment of the silicone bend. So now I am not sure if the broken ear or band that caused the sensor to fall off. Now I have to wrap it with tape after mounting so it doesn't come off. After less than 500 miles, that's pretty fragile. It might be the reason I lost the original one. Dropping from 5 stars to 3. One thing I also noticed is the cadence update is a few seconds behind, so if you mount this on your stationary bike and want to see your peak cadence, you are not going to get that. Original review ---- This is a replacement for my last Coospo sensor that fell off my crank. The replacment works fine as expected. I do like the fact it has ANT+ and BLE, so it could send data to my bike computer and phone at the same time. Weird that a 2 pack cost more than 2 single pack, which is what I purchased. I read you can't pair both at the same time via BLE, but I using another brand's speed sensor, which is no problem. A couple of minor issues. The form factor is squarish, which makes it stick out when attached to a hub or to my old school crank. This time, I mounted in between the spider on the chainring side so nothing would bump into it (unless a dropped chain does). The other thing is removing the battery to change between cadence and speed sensor mode. I've had others where there is a tiny switch internally. By the time the battery needs to be changed, I would have forgotten if the blue or red light indicates it being in cadence mode. I would find out there is no cadence reading, then have to go into the app or bike computer to see what type of device is discovered. Probably have to stuff the instruction into somewhere obvious, which I would not remember 8 months down the line.

Great combo , small price ! Easy installation and accurate reading.

I've been using this cadence sensor for over a year now and feel driven to review it at this point. This is due to the low drama experience I have had with this product. I've been running this for road cycling with about 2,863 cumalative miles logged. I have experienced several rainstorms also during my this time while riding. No issues. Pros- Battery life- original battery lasted over a year Dependable-always works and always connects (I use ant+) Accurate- I have a cadence range I prefer and this sensor has always lined up with my expectations and experience. Reacts quick enough to changes. No complaints when going from 0 to 100 to 0 cadence. This mostly happens in pace group. Neutral thoughts on the rubber rings. They are a wear item that I've had to be creative to replace. They will not last long. Understandably. Cons-none.

I have had the CooSpo heart rate monitor with great success and usability. So I ordered the speed and candence sensors. They arrived quickly. The picture directions are clear about the install. Setting the modes between speed and candence is as simple as removing and replacing the battery. The connection to the Wahoo Bolt was quick. I connected using ANT+ since it had the strongest signal at a distance. The Bluetooth connection did show a weaker signal. Also Bluetooth in general uses a crowded spectrum so living in a urban population, the use of ANT+ is better. During my first rides they work great! The speed sensor wakes up at about 4-5mph after that it's accurate from 0 on your ride. There is a latency I noticed of 1-3 seconds in the data to the head unit. These sensors replace the Wahoo BlueSC and are far better than the magnet sensors. For durability, I am not sure how long the rubber neoprene bands will last. They give you many extra bands. I'll update my review if I have an issue. Great buy, easy to use, excellent value! I would recommend them.

The units are quickly recognized by iOS and Android. Wahoo also recognizes the devices. They are initially “seen” as cadence/speed. Android and Wahoo identify the Ant+ signal and the setting of cadence OR speed that is set when placing/replacing the battery as directed in the manual. I found it easiest to pair one at a time with the other “asleep”. Pairing the speed first was the easiest way to keep the sensor asleep while pairing the cadence, but the pairing can be done in any order before installing. Just remember or mark them to distinguish as they appear identical. iOS will pair with both, but in use will only recognize one or the other. The ble id does not allow me to use both at the same time. I attempted to pair them as one does for multiple earphones, but got wildly inaccurate data. There is a delay in the slope data for climbs and it varies based on ascent bs descent. The speed is accurate or the distance of a ride (avg), but may vary +\- 0.5 mph for the current velocity (compared between android phone, wahoo ELEMNT, and wheel mount magnet with measured circ. Overall a good value for money that offers decent accuracy with some tolerance for error. Issues with pairing are primarily due to lack of any+ on the iOS and the dual ble signal of the units.

Just finished trying to set them up. One came on immediately and worked fine for cadence. The other never lit up but I was able to pair. It lost connection 5 minutes later. I paired again, no data. Lost connection a few minutes later.

Connects very easy to my smart phone.

Super

Muy fácil de instalar y poner en marcha, funciona perfectamente.

Very happy! Garmin can make a hole in the wallet. It has no signal transmission issue. I have been using it for 2 months now.

ممتاز

I bought this product for using on my Indoor trainer. This is working well with my bike computer as well. Its really awesome!