🔧 Upgrade your classic Chevy with billet brilliance—because your ride deserves the best!
The A-Team Performance Headlight Switch Assembly features a durable billet aluminum knob and dash knobs, designed specifically for 1968-1984 Chevy GM street rod trucks. With a standard 8-terminal GM plug, it offers easy installation and reliable on/off control, combining precision engineering with stylish functionality to enhance both performance and interior aesthetics.
| ASIN | B01N7CS77Z |
| Actuator Type | Knob |
| Best Sellers Rank | #175,217 in Automotive ( See Top 100 in Automotive ) #121 in Automotive Headlight Switches |
| Brand | A-Team Performance |
| Circuit Type | 1-way |
| Compatible Devices | 1968-1984 Chevy GM models |
| Connectivity Protocol | X-10 |
| Connector Type | Plug In |
| Contact Material | Aluminum |
| Contact Type | Normally Open |
| Control Method | Touch |
| Control Type | on/off |
| Date First Available | December 1, 2016 |
| International Protection Rating | IP00 |
| Is Discontinued By Manufacturer | No |
| Item Weight | 1.6 ounces |
| Manufacturer | A-Team Performance |
| Number of Positions | 8 |
| Operating Voltage | 12 Volts (DC) |
| Operation Mode | Off |
| Package Dimensions | 7.09 x 2.56 x 2.28 inches |
| Terminal | Physical |
| Unit Count | 1 Count |
| Vehicle Service Type | 1968-1984 Chevy GM Street Rod Trucks |
T**O
Worked on 1979 G20 Van
Works on 1979 G20 Chevrolet Van. Turned the lights on and off. Plugged in easily. Looks like OEM Quality.
S**M
good item
As described. Quick delivery. Would purchase again.
L**R
works
In car working great
A**R
Switch
Great
K**E
Worked
Worked and fit in 84 GMC Van
F**.
will not fit GM cars older than 1967 without modification. SEE BELOW
I had to replace my 1964 vintage switch in my dune buggy because the fastening knob threads stripped. I had to remove / install it several times during the wiring process. This switch was upgraded in 1968 to use a slightly larger nut with courser threads - a big improvement. When using this to replace the earlier switch all you have to do is enlarge the mounting hole to 7/16" and it will fit fine. Don't forget to notch the hole for the anti rotation tab on the switch housing.
M**Y
Fits and Works well
Fits and Works well
A**E
Great switch for my 1938 dodge
I added an overhead dome light and wanted a simple switch that would do all the lights, instruments and dome light using the negative contacts since my 21 fuse aftermarket harness was wired as such. Worked great but the contacts for the dome could have been thicker so that the pressure to push against the metal body would retract fully as opposed to slowly getting closer and closer and eventually the contacts stays on all the time until you gently pull it up again. I may try something myself
M**M
Funcional
