VCELINKRight Angle Banana Plugs 4 Pairs/8 Pack, 90 Degree 4mm 24K Gold Plated Dual Screw Type Speaker Connector for Speaker Wire, Red and Black

First this review is of my positive experience it’s not meant to argue or put down someone’s negative experience. I was a little skeptical about these based on a couple of the negative reviews, but figured if they’re junk I’ll return them. I’m very happy I bought these. I am a retired audio engineer and have worked with pretty much any cable or connectors made. Price, these are $1.12 each before tax I saw them from as low as .85ea in bulk to stupid expensive. The ones I received are very well made I tried to pull them apart and couldn’t. I installed these on Monster 12 gauge speaker wire and they fit perfect. One review stated caution on heavier than 14g but these easily handled the 10g I tested just to see. Bear in mind the wire gauge is always the same but the insulation thickness can vary depending on the manufacturer. The insulating sleeve just barely went over the wire insulation as the Monster wire has really thick insulation, had to put a little dish soap to get it to slide on. Yes the insulating sleeves are hard to get off the connectors if you pull on them, if you push them off with your thumb nail they slide right off. The set screws seem to hold well, if you’re worried they may loosen over time put a tiny bit of Tightlock or silicone adhesive on the threads it will hold it tight but you can still unscrew it with a screwdriver if need be. I would purchase these again if needed and would recommend them to anyone needing a few, if you need a lot I’d look for the bulk packages. Aloha

These banana plugs are great. I used them for all speakers to reduce stress on speaker terminals and save space. Paired with InstallGear 14 Gauge AWG Oxygen-Free Speaker Wire with zero issues. There was enough space to easily take proper-sized 12 Gauge wire. Banana plug fit is snug, I had zero issues connecting them the first time and disconnecting from speakers several times during installation. For those who are using banana plugs for the first time don't panic - they ARE supposed to go tight for the first time since you are slightly compressing the ribs for a precise match with speaker/wall terminals. Measured electric resistance and it's extremely low comparable to solid copper connectors. No issues with conductivity. I installed a total of 18 of these plugs for my setup and had absolutely no issues with screws or assembly. It's NOT EASY to slide plastic sleeves off if you are pulling them directly - slide them off in a circular motion instead while pulling metal assembly out.

初めて知ったパーツに驚き。（物知らずだった私）アンプとスピーカーを壁際に設置ができて最高です。更に、音質も改善されて大変満足しています。

Easy to attach; double screws on each plug ensure secure cable fixing into the plug. I now have these connecting a Topping amp with quite small binding posts to some Wharfedale speakers. The insulation sleeves prevent any nasty shorts from occurring.Well packaged in vcelink branded packaging.

These are nice and heavy-duty, and are very easy to hook up to any wire using a small flat screwdriver - you insert the wire a fair length into the end and then tighten both of the screws - one near the end and another closer to the plug. It will take a pretty heavy gauge wire and seems it could handle quite a bit of current.