VANJINGCompatible with 4WD Transfer Case Shift Encoder Motor Actuator Chevy Silverado Tahoe Avalanche Suburban Dodge Ram 1500 2500 GMC Sierra Yukon 2003-2010 Replaces 600-910 19125571 5170543AA

Buena calidad, cumple con su función.Recomendable !!!

I installed this and it was worse than the one I took off, the lights on the dash didn’t even come on.

Installed 4WD Transfer Case Shift Encoder Motor which wasn't very hard. I also changed the Transfer case fluid. After getting it installed, all in the proper order and correctly, So I thought. I started up the 03 Tahoe Z71 and had it in 2 wheel drive. I pressed the 4x4 button and it went in to Auto 4x4. WHAT? I push the 2 wheel button again and it went right in to 2x. Ok! I pressed the 4 Low, went in to 4 Low no problem. I pressed the 4x4 button again and it went to 4 Auto again. Not 4x4 Didn't make sense. I went through this a few times. So I decided to see if it was the switch. Before I replaced the switch, I disconnected the battery and realized that was the new switch. I put the switch back in, reconnected the battery and was on my way to the auto shop, to see about getting it on a scope when I decided to press the 4x4 while doing maybe 20 MPH and what do you know, it went in to 4x4. I think disconnecting the battery reset the TCCM. Been working fine every since. I left the battery hooked up in order to make sure the encoder motor was in the proper position before I installed it by pressing the 2 wheel button before mounting it to the TC. I should have disconnected battery once I knew it was in 2 wheel. So if you have that problem, here's the reason. Disconnect the battery before mounting the encoder motor. Than reconnect it when done.

Very good replacement

It worked and fit my vehicle