Poweka Carburetor + Intake Manifold + Gaskets for Honda Gx160 5.5Hp Gx200 6.5Hp Generator Water Pump Chinese Engine New UPC: 639713899290

This carb was used to replace old carb on ryan aerator and works great. Aerator runs great again. Would been 5 stars but tiny piece of plastic was found broken when I opened the box..

I have a pressure washer with this motor on it... It must be 20 years old! I swore that I couldn't break the pressure washer if I tried... Then the motor wouldn't start. I could get it to start with starter fluid so I ruled out the ignition coil and spark plug. If it's not the spark, it's the carburetor. I bought this carburetor on a hope and a prayer because a new pressure washer like mine is around $800.00.Because of the motor's age, I did replace the coil, plugs, air filter, and oil as well. The motor cranked right up 2nd pull and runs smooth as can be just like new!! I was skeptical because it was so inexpensive! I think the ethanol in gasoline these days messes up carburetors. In the future instead of using the on/off switch to kill the motor, I am going to use the fuel cutoff switch so all the gas in the carburetor burns off and doesn't build up gunk.I highly recommend this product!

After ,making the mistake to leave my Honda clone GX200 with gasoline with 10% ethanol for more than a year , the Original carburetor was completely bad, so I decide to purchase this carburetor to put in my engine, it did fit perfectly and my engine started first pull , So I am very happy with the Carburetor and the price is great , so I highly recommend this unit for your Honda or Honda clone GX series engine.Also to avoid future problems with your carburetors I highly recommenced to use Gasoline w/o ethanol (Ethanol Free), You can buy TRUEFUEL in Amazon or Home depot etc etc, or at least use some fuel stabilizer like Stat-Bil (use the marine version is better) . I learn my lesson , I will not use any more gasoline with ethanol in my small engines.,

I have a Home Depot power washer that had gasoline in it for two years without using. Needless to say, the carb gunked up and the needle must have stuck. It ran but it gushed gasoline through the carburetor overflow outlet. Rather than paying the shop $150 to clean the carb, I bought this carburetor and replaced it myself. It was amazing how it dropped right in! Carburetor + Intake Manifold + Gaskets for Honda Gx160 5.5Hp Gx200 6.5Hp Generator Water Pump Chinese Engine New  Identical form, fit and function. The description says that this is for a Honda engine. I don't think mine is a Honda engine. However, the carb that it came with looks almost identical to the Honda one.

My Honda GX200 clone engine starting starving for fuel, would not run without 1/2 choke left on. I tried everything before resorting to replacing the carb with this one. This carb worked perfectly and the gaskets were perfect. I also discovered the source of all of my problems (I rebuild the old carb three times) There is an air vent between the cylinder and carb that was hidden by the gasket. This vent was clogged with dirt. Now the engine (Its a Harbor Freight Greyhound/Lifan engine) runs great at full throttle

Seller sent part for GX200 instead and then resent GX160 part. Gaskets weren't the right ones either. This product takes a while to ship since it is from China. Not a genuine Honda part, but works just as well as the real thing.

Great little carb for the money. Clearly not OEM, but it is not for sale at OEM prices either. Bought another just to keep on hand should this one fail. For the price, I would say this product is more than fair.

Was looking for a replacement carb for my GX200 , was kind of skeptical buying this at first but after reading the positive feedback I took a chance for the cost. Installed it along with the new fuel line , added some fresh fuel and started on the first pull. Even if this thing lasts a year or two ? Can't beat it for the price. Might order another one to keep as a spare.

Not impress with the package I received mostly because the carburator doesn't fit. I have 160 model and I guess thet sent me a 200 model. At least the package contains gaskets that I could use.It was a try. I will stick with books for now....

beaucoup moin cher que l'original et aussi bonne qualitée bon service de livraison

Piece of Chinese made junk?

motor is running great now

Double right on!!