Nilight Headlight Assembly For 1999 2000 2001 2002 Chevy Silverado Avalanche 1500 1500Hd 2500 2500Hd 3500 Chevrolet Tahoe Suburban Replacement Headlamp Housing Bumper Lights Set, 2 Years Warranty

Arrived this morning and installed this morning. 2003 Chevy Tahoe. Easy install, takes about 20 minutes total to remove the old and install the new. Crystal clear, very bright with my Sylvania ZXE Gold bulbs, beautiful transformation, really improves the look of my truck, perfect fitment, no gaps anywhere, tight fit. I would definitely recommend these light assemblies to anyone needing some great lights and if ever needed I would definitely buy them again. Tips: Before installation, adjust the up/down screws in until they are about 1/2 an inch long, they are set too far back from the factory and will make it seem as though they aren't going to fit. Disconnect your bulbs and place the bulbs in the assembly then, connect your harness back up, the low beam bulb fitment is very tight and will be hard to connect with the harness on. Be sure to check daytime running and signal assembly and make sure you have the correct lights for the side that you are getting ready to put on, they will fit bavkwards but you'll notice it's really tight and will have a bad gap (Ask me how I know😂) Overall I am 200% satisfied with this purchase. The fog lights were purchased 2 years ago from Topscope, they still look great and perform great.

Typical fast Amazon shipping, great packaging. Lights look great and fit well with small alteration. The headlight bulbs themselves are a VERY tight fit, I used a bit of spray silicon on my finger and wiped the 'O' ring and where it twists into the housing. The left-hand park lamp has two 'tits' that press against the mounting panel, and they seemed to be about 3/16" to long, I used a grinder and then they snapped right in place. The lens are crystal clear and the reflectors seem to be high quality. Be careful, the black mounting panels are thin plastic and would break easy, a little lube is your friend!

These headlight assemblies are very clear and bright. They were a little tricky getting in place, but with some fanagling I finally got them seated so I could slide in the holding rods. One of the adjuster blocks broke and I got a replacement. The common complaint with these assemblies is the lateral and elevation adjustments don’t work or break, and that was the case with my first set. All the brands seem to have this issue. So here’s my work around in the second set: I used super glue (jb weld would be better) on the adjustment screw anchor point and beefed up the plastic mounting point. The adjustment screw is very rough and poorly machined, and that contributed to the first adjusters breaking. So I used silicone oil on the screws, and dripped some into the jackscrew block mechanism. I also marked the direction for each adjusting nut so as to avoid any unnecessary turns. And lastly, I was very gentle adjusting the elevation and lateral movements. It all seemed to work out. I’m probably like a lot of you and resent having to do diy on new products, but the alternative to these $85 lights are OEM at $400-nuff said!

Nice looking product BUT made extremely cheap , the passenger side main headlight had 2 screws missin, took 2 outta the old one to put in where they didn't also the same one a screw set is way to big for the set screw will not stay in place , im gonna try JB Weld today see if that will hold it , yep highly upset , I do not recommend anyone buyin this brand for headlights, I know I will NOT 💯

Bought these headlights for my suburban they are super easy to install and look very clean and sick. But only problem I had with mine is my driver side lower headlights bracket broke, so be very careful installing and take your time. But for 60 some dollars they are really nice and would recommend they to anyone