10 Pair for Amass XT60H Upgraded Version XT60 Connectors with Covers Male Female Power Plug with Sheath for Lipo Battery RC Planes Cars

I wanted to try these out since everyone is switching to they, get away from deans/t-plug because they are easier to solder and gripping em with the hands are easier. I wasn't disappointed. To solder I simply plugged male and female connections together and easily soldered wire connections. The reason why I connected male to female is a simple notion. Plastic can get loose with heat. If this does occur, the connectors can become misaligned. Keeping em together allows the plastic to cool and remain aligned. This was not always the case with deans/t-plugs. Those need to get ridiculously hot just to solder them. Plastic always melted. Not so with the Xt60 connector. I've not seen a hint of the plastic over heating because it doesn't take as much time to heat things up. The added dimensions of the Xt60 make it much easier to pull em apart vs the deans/t-plugs

As a veteran electronics technician. these things are great for my bench power supplies to the various experiments that I'm always doing. Just have one end always hooked up to the source, terminated with one of these, and I have reliable power to the unit under test by building the opposite pigtail. Great quality IMO. I'll get many connect-cycles before one ever needs replacement. At this great price, might buy another order just to future proof my supply. UPDATE: Bought again. These things a pro and a great value. Good for any power project where you need to have a solid connection. UPDATE Again: Bought again. Great for any geeky project requiring polarizing your wiring and need to run power.

Bought these XT60's because of the upgraded way the wire connec2tions are protected. No heatshrink required and the black cap has a wall that separates the 2 wires. Makes installing an XT60 faster and the finished product looks better. The only con is that these connectors have a tight fit making them a little hard to pull apart.

These are excellent connectors. Once you solder them up correctly you dont have to worry about crossing +/-. The rubber boots are great for covering the soldered points. Yes, you have to solder, but then you know you have a solid connection. These are a favorite of my FRC robotics team.

The connectors come paired male&female. I have used this type before but never installed them. I expected the wires would either crimp or soldier on. The terminal's come with what I would call a soldier cup. The male ends look fine but the female ends appear to be blocked off; that is not drilled as deep as the male connectors. This is something new to me and as far as I know they may be sold this way. I have not contacted the seller about this due to this is a small job and I'll make them work. Other then that; everything was fine. The package arrived on time and in good shape.

I didn't buy these for RC cars. My Creality Ender 3 printer uses this plug from the power supply over to the mainboard. They use cheap Chinese XT60 connectors which have been known to be a fire hazard. Sure enough, my connector on my 3d printer was starting to melt. I purchased these, swapped it out, started another print job, and felt the new connector. Didn't feel hot at all. Great quality connectors! Love them.

Easy to solder, the Caps are great so you don't need shrink tubes.. get a good soldering iron, tin the end of your wires heavily so there's a drop of solder on the end, hold it to the connector (black to - red to +) and hold your soldering iron on the drip until it flows and you're done..

These connectors fit tightly and snugly, and are high quality plastic. Even with extended heating via the soldering iron they get very hot but do not melt or soften. I have tested then to withstand upto 20 Amps continuously with no heating. Ypur wires will fail before these connectors.