799868 Carburetor Compatible with Briggs & Stratton 498170 799872 694202 497586 498254 790821-14111 Carburetor +795259 Air Filter Cleaner Primer Base By LEIMO

Perfect fit! This was an exact replacement and the mower started right up and has been running great. I did not use the Spark plug yet, but that is next. Installation was fast and easy. Superior value for the money, thanks!

It fit the mower. It seems to work pretty good. It's a lot lighter than the original. So not OEM quality at all. It has a few more plastic parts. But it's cheap and it will make an old mower work for a few more years. It I also has all the accessories you would need.

I had my doubts, considering the low cost. I've used inexpensive after market carburetors on small engines before with mixed results. If you look at the throttle plate in a carburetor like this, compared to an OEM, the fit is pretty sloppy, with visible air gaps around it. The good news is that really doesn't matter on a lawn mower because you aren't running it at a low idle. So I found this carb fit perfectly, and ran fine. They were thoughtful enough to send two gaskets, which are often needed to seal the plastic plate properly. The priming bulb worked well also. In fact, everything included worked well. An awful lot of thought goes into a kit like this. It includes every little thing that you might need. That speaks well for the manufacturer/supplier. Five stars plus.

You may have to use both backing plate gaskets unit to get the primer unit to work, that's probably why they include two gaskets! If you search the internet, this is a known fact even with the OEM units!Works great, but instructions pointing this out would have saved me some troubleshooting time, after the install with just one backing plate gasket my mower would not start without starting fluid, once warm it would start fine. I found in other reviews mention of this and volia, it starts fine from cold condition now!

Old mower had not been used for 8 years. The carburetor bowl was rusted and the fuel inlet needle was seized in the seat. Not fixable so I tried this aftermarket carb. Due to some reviews reported leakage before I installed it I removed the bowl to verify the float height closed the inlet needle when level. All looked good. Installation was easy and now the old mower runs good. Maybe I got lucky but very pleased.

Worked as it should and was almost the same price as the rebuild kit. Saved a lot of time and headache.

I pulled my walk behind weed eater out of the garage having a vague memory of it not working a few years ago when I tried it last. I figured that like most small engine issues I've dealt with - it was probably a gummed up carburetor and these days a new one is less than $30 - so I ordered this replacement. Easy fix - I thought. When it arrived I installed it and was confused that the engine did NOT run well with it. I don't know all of the proper terminology so it is hard to describe small engine symptoms... but it sort of stuttered along at an idle and would not run smoothly. I was sure that I had done something wrong on the install - and so took it off - checked everything to make sure that the moving parts moved, put on a different spark plug just in case that was the issue, put the carb back on and started it again. Same issue. It just kind of barely ran. In a last ditch effort, I put the old carb back on to see what it would do - and was surprised that it ran flawlessly. Which of course made me wonder why I didn't test the thing out right away before buying the new carb. But in any case - bottom line is that the carb that was sent to me, even though it looked identical in every way to the original one and appeared to be in good shape, did not work at all. In the end I'm not positive what the issue is - but the evidence points to either a poor quality product or poor quality assurance testing at the factory.

Works flawlessly