Amazon Basics 1/2-inch Drive Click Torque Wrench - 20-150 foot-lb, 27.1-203.5 Nm

Came in a sturdy plastic case. Gets the job done.

Over all good little inch/lb torque wrench. I have not tested calibration but I did replace oil cooler, lower intake, rocker arms and valve covers with no issues.

Needed to swap out a part on my ride and it called for 10.0 NM per bolt, I was afraid to strip these very cheap Harley bolts and many folks end up with bolts that are damaged and a headache, so I first tested it against my spark plugs as they called for 6NM and heard the click, I was pretty sure the plugs did not need much after hand tight and quarter turn, immediately I heard the click, then I tried another screw that called for just over 10NM and heard the click, so I proceeded to the bolts on the transmission cover and was scared at first since it tightened more than anticipated and heard the click, and the others the same, click, click, click and on one screw not many turns and click. Result? No spills from transmission oil and perfect tight without worrying of stripping the bolts. So far so good, for the cheap price, I’ll take it. The BAD, the screw at the bottom is hard to loosen up and if you need to use the upper limits, it gets really hard to turn but it turns. The good- Great instructions with the manual for first time users. No certification of calibration, but honestly do you trust a Chinese piece of paper from the others?

Needed to replace struts on my car which calls for 200+ foot-lb of torque. My largest wrench would go only to 80, so got this one. No issues applying required force even though I'm only 140 lb myself. This wrench is great and inexpensive, large size made the job easy.

Made well works great.

I bought this to make sure I didn’t over torque a bolt. Before I went to use it I wanted to test it in some fashion to make sure it would click around where I thought it should. I put a socket in and attached it to a hex key that I slid into a pipe. I then started applying force. It didn’t click around where I thought it should so kept pushing harder and harder until the head on the wrench finally snapped! I had it set to only 20 inch pounds and never got any indication I had had it. Avoid this wrench if you want to make sure you don’t over tighten something.

good quality function price

As title states this is probably the best 1/4 budget torque wrench. I was a bit skeptical because its amazon brand however it's a decent product. I already have tekton 3/8 and 1/2 torque wrenches, but I wanted something that could cover lower torque specs the issue with using bigger torque wrenches it's hard to hear the click on lower torques and might not click at all unless you have an expensive one. This product will save you from over torquing. If you need something to torque down things in inch lbs like oil pans or valve covers this definitely will get it done accurately.