Question 1

Is this treadmill  motorised

Accepted Answer

Hi
This product is a replacement belt for this machine.

Regards
David

Question 2

Hi is this an electronic treadmill and whats the measurements

Accepted Answer

Hi
For a some reason, Amazon have allocated an incorrect photo to this product, our product is a replacement belt for this machine.

Regards 
David

Question 3

Is this compatible with a Reebok jet 300?

Accepted Answer

Hi
Unfortunately we don't have the details of that belt in our database, but if you could measure it, we will be able to make you a belt that will fit your machine. Below are some instructions for measuring your belt, if you have any problems just get in touch.

Regards
David

On the machine

Most treadmill belts can be pushed around whilst on the treadmill.

Put a clear mark in the middle of the belt at the end you stand on.
Measure 800mm or so and make another mark. Push the belt around and make another mark
800mm or so away. Keep on doing this around the belt and measure the final gap between the marks. Add them up and you have measured the outside length of the belt.

The belt is under tension whilst on the treadmill. This allows it to drive and track properly.
The roller/drum can be moved backwards or forwards to apply or decrease tension in the belt. It will usually have a total adjustment of 50/100mm or so. Measure the total adjustment available, and then measure the position of the roller centre shaft relative to either end of the adjustment. Make a note of both measurements, and where they were taken from.

We need this information so that we can work out the length of the belt we will supply you with, before it is put on the machine and tensioned and tracked.

Off the machine

After removing the belt, if time permits, leave it for 12/24 hours to relax before measuring. It has been under tension for some time and will have stretched. Once off the machine it tries to revert to its original length, but never quite makes it.

The belt is easily measured on the inside or outside. The outside will be longer than the inside.

If the belt cannot be used again then cut it in half and then measure the length from the same position on either end. Do not forget to measure the width.

Ideally a new belt when fitted will use one third of the total adjustment available. If there is 90mm total adjustment then a new belt will end up using 30mm. This allows enough extra length for the belt to be fitted easily, plus the tensioning, plus extra for clearance.

Question 4

Hi. i have a trimline motorised treadmill that needs a new belt. it’s 2.57m long and 44.5cm wide. can you recommend a belt that would fit?

Accepted Answer

Hi
If you use one of the following links, they are for belts that will fit your machine. The difference between the two is, one is a 1ply belt and the other is a 2ply belt. The difference between a 1ply belt and a 2ply belt is, a 2ply belt is made of a heavier duty material and does not need lubrication, where as the 1ply belt is made of a lighter material and needs to be lubricated every so often. (The 1ply belt comes with a bottle of lubricant)

Regards
David

https://www.amazon.co.uk/dp/B07RCY46RB?ref=myi_title_dp
https://www.amazon.co.uk/dp/B07RCWVP9J?ref=myi_title_dp

GB BELTING LIMITED Reebok Z8 Run RE1M-1170 Home Use 1 Ply Replacement Treadmill Belt

描述

有问题吗？看看别人问了什么

评论

常见问题