GOQOTOMO E-600 5.8G Wireless Color Audio-Video Receiver and Transmitter Kit for Safety Backup Camera System/Rear View Camera System

I have the receiver connected to a flip down monitor on the dash of my truck, with a concealed wire to the back window. I attached the power to one of the Ford auxiliary switches so I can shut it off when it is not in use. From the receiver on the back window to the transmitter (sender) inside the fifth wheel all metal hitch pin box and it works every time. The sender is inside that pin box and is connected to the parking lights for power. If the lights are not on from the truck, through the pigtail, then the sender is not on either. This setup allows me to connect my fifth wheel as usual with out having to think about an additional connection for my camera. It works flawlessly. I did have to buy additional connectors like a barrel RCA connector and also a BNC connector for my camera, but each camera and monitor connection is different and not all use RCA connectors. I am very happy with my purchase. Make sure you connect all the Red wire pigtails to a 12 volt power source or this will not work. The receiver has no ground wire and can ground through the RCA shield. The sender has both a hot and a ground and both must be connected. When wired correctly this also supplies power to the camera.

At first purchase the cheaper one and they sucked. Then I purchased these for replacement and wowe what a difference, definitely happy with this product, makes it easier to see what's behind me when towing my 31ft camper.

They work, but pick up noise in the application i used them in. From back of motor home license plate to radio in dash. A distance of 20 feet with a lot of metal in between. Ended up going with a hard wire installation.

The units are fairly easy to install, but if the camera is in the bright intense sun it loses imaging, to where u can only see in a crappy resolution, and everything is blurred! So, keep out of direct sunlight and intense light!

The tx/rx works great. The only draw back is the channel is fixed and not adjustable. Meaning that if you buy more than one, they are all broadcasting on the same channel.I tried to use two sets of these, but the signals would interfere. I ended up having to buy a completely different tx/rx pair for my project.

I have forward and rear cameras mounted, besides the factory backup camera, on my 2015 GMC Sierra. It is lifted 8.5 inches so they're extremely helpful in parking lots and other crowded situations. As my hood is higher than most of the cars in the lot. Lol. I bought the wireless transmitter so I could mount a led camera inside my enclosed trailer. When I am hauling my Harleys I would be able to keep an eye inside. This would've saved me the trouble of running video cable to the back of the truck, as well as running a video cable in the trailer. It doesn't work. They're terrible. It's not interference from being inside the trailer. Even when I stick the transmitter out the door it still doesn't work. I've tried 2 different cameras. Now I'm running video cable. Oh well. Was a great thought.

Bought these to wirelessly send a signalFrom my aftermarket stereo to the rear DVD player in my truck and it worked great! Just added a power switch for the rear DVD player to control when it receives the video signal and it sends clear picture between the two so I’m overall very happy with the product .

Works so far. I parked my truck 30 feet away from the trailer and still had a picture. The transmitter is pushed up through the dome vent in the enclosed trailer. The receiver is behind the radio in the dash. Do not use scotch lock connectors to splice into the wires . the wires on the receiver are too small and too problematic with scotch locks cut twist solder heat shrink do it right do you’ll have a great outcome

Works well. Fulfilled my need.

Easy to connect works as expected, it's great.

Transmitter cut out when hot.There was no heat sinks on the output semi conductor.Fitted one know works fine