NEWDERY External Battery Station for Nintendo Switch, 10000mAh Backup Portable Charger Case with Quick Charging, 2 Extra Game Card Slots, Adjustable Kickstand

My hardware: OG V1 Switch, fully cleaned of dust. Installed an aftermarket (and allegedly better than stock) fan and battery and with newly applied (high quality) thermal paste.I exclusively play in handheld mode and overclock just enough to make the targeted framerate (either 30fps or 60fps depending on the game) rock solid.With that context in mind, this battery grip offers two big advantages for overclocking:1. Much longer battery life. I am talking I was getting maybe 2.5 hours max before this device (about 80% brightness, speakers on about 70%, with airplane mode on) and now with the device I haven't managed to deplete the battery pack in a single day (talking like 7+ hours of OC'd Xenoblade). I imagine a V2 or OLED will get even more battery time especially with stock clocks.I'll try and do specific max time testing and update the review with those numbers at some point.2. More overclock options. Let me explain. Using "sys-clk" you are limited in the max clocks you can use in handheld mode, unless you are acticely plugged into a charger. This device counts as a "usb charger" which will increase your GPU handheld OC options from:GPUStock 307MHzOC handheld max 460MHz*OC handheld max w/this device 768MHz*So what's the big deal? Many games can hit a mostly solid 30fps/60fps (again depending on the game's target) with the 460MHz OC option that you can get without this device, however many games will still have areas or certain actions (spells, dense mobs, or something) that can tank the FPS for a few seconds or until you leave that area. If you're like me, that will bug you and this is your solution.I find the 537MHz option (which is not possible without being tethered to a charger or by using this device) eliminates almost any and all dips. Even then, you still have the option of 614MHz, 691MHz, and 768MHz (which is docked mode clocks btw) to smooth out any additional dips, should you wish. Prodeus (w/ shadows) being the most intense I've found, needing 537MHz & a high CPU clock 1428MHz just to hit 30fps, and more to reduce dips.I personally don't like to go above 537MHz because I hate fan noise and even 537MHz pushes fan spin to around 35% which is almost loud enough to annoy me personally, at least without headphones on. I also find that if the clocks have to be pushed past 537MHz for handheld targets, the game is probably just poorly optimized and either nothing will make it stable or it is cpu bottlenecked and you need to bump up CPU clocks as well.So what are the drawbacks?1. Heavy. Like I would never lay on my back and hold it above my face heavy because it might break a nose or chip a tooth if I drop it heavy. This is more of a use your thighs to prop it while you play unless you really want carpal tunnel heavy. Switch is 1lb 11.6 oz (or 27.6 oz total) with the grip and 14.8 oz without. It's a pretty big difference at almost double the weight. If I were the company I would offer one with half the capacity and weight for the mainstream market. Obviously I am glad this exists in this form as I value the capacity over the weight but I feel like I am pretty niche in this preference.Side note, I don't really use the stand but it is far better than the V1 Switch stand. Tabletop mode + the usb slots the grip has on top + pro controller might make for a great alternative to counter the weight issue.2. It is big. I imagine it would be problamatic for someone with small hands but for me it is just right. I can play bass and 12 string guitars pretty comfortably for reference.3. It's a little smooth. Same smoothness as the Joycons but in my opinion that is a little too smooth with the added weight. I haven't had any close calls (yet) but I do have to be mindful to not hold it with one hand as the smoothness plus the additional weight (and some sweaty palms) could lead to a pretty catastrophic drop. Still coming up with a home solution for this but it might just be grip tape around the whole outer perimeter where your hands cup the grip.Summary:For me, overall it is far more comfortable than without a grip, which is why I originally purchased this. I don't feel like my hands have to turn into spider legs to hit the triggers anymore or feel like the joycons are flexing ever so slightly. Just feels more solid overall.I truly thought the battery would give me an extra hour or so back (you know, return the battery time lost from overclocking), not give me an extra 6+ with overclocking. Not having to worry about afternoon charging to be able to play it again at night is really nice. The additional overclocking options are a huge (and entirely unforseen) bonus as someone who plays exclusively handheld and hates fps dips.No external heat that I can detect on the grip (at all) but the internal temps seem to run a little higher abt 3 to 5 degrees (which just equates to more fan spin, nothing more), so I will probably remove the intake grills on the grip like the other reviewer suggested and see if that brings it back down.Edit: Removed the fabric mesh and the "tape" mesh from both the intake holes on the grip and the temp dropped back down about 5 degrees on average under the same load. Two layers and both were pretty fine/small openings so I am not surprised airflow was a little restricted.Worth every penny. Hope this review helps out a very specific person or persons. I will try and answer any questions asked about the device.

My OLED used to last about 2 hours game play. Now with this battery it lasts about 40 hours. Although is is a bit heavy about doubles the wieght of your Switch. It does not bother me cause I mostly play on my lap. It is built solid no flexing whatsoever. Feels nice in the hands and has nice grip texture. Inside is lined with soft felt so it will not scratch your switch. It does have super fast charging for the Switch and let's you know it is enabled by a green light. But the battery pack itself uses 7 watts and slow charges. I play several hours a day and just charge it overnight once a week. I was skeptical about the 10000mah battery so I took it apart to check. I side is two chunky 5000mah batteries. So yes it really is 10000mah. As far as longevity I think it will last because of what I saw inside. Thick wires and overall well made. Sorry I did not take a picture when I had it open. I did not want to open it again just for picture for this review. I don't want to break it or strip out the screws. I hope this review helps. Thank You

Overall the case works well. Quiet, not overly heavy and battery only went down like 25% after around 6 hoursSome issues at first with fitting my OLED switch.Seller contacted me and it was determined I got sent wrong case as the OLED version had just been updated. They sent me the updated case for OLED and it fits soooooo much better. Got here in about a day.Top notch customer service. Little rocky start but alls well that ends well and they did a wonderful job reaching out.They also have a 12 month warranty on this product. Additionally they’ve continued to reach out to make sure I’m taken care of. Product fits perfectly, works like a charm, this company’s customer service is pretty rad and the warranty to boot. Get the case, it’s worth it.

I debated a bit whether to give this 4 or 5 stars. I really want to give it 5, but there's two things holding that back. First the good though. I love this thing! It is very comfortable to hold, the plastic has a nice and velvety soft coating on it. My main concern when looking at this was how well the switch would stay in. Very happy to say that is not any issue at all. The inside is felt lined which adds some grip, and the top has a slight overhang to help hold the switch in place. It stays in there very securely and actually takes a bit of force to remove it.Now to those two issues. The first one is heat, as others have noted. The switch does heat up a bit while using this thing. There are vents on the external battery that line up with the switch's intake vents, but it still doesn't allow enough air through it. That said though, it never really gets that hot. I only noticed it when I took the switch out to put it in the dock and felt that it was just slightly warm. It seems to me to get about as hot as when playing docked at 1080p. In my eye, that isn't enough to knock a star. NOTE: I do have the second/newer switch model with improved proc.The second issue though is getting to me a bit. When removing the switch, you have to slide it straight up. This is basically the opposite of how you take it out of cases. Normally you would pull the switch out from the front at the top end first. It's a habit that you will need to break because this will cause the usb connector to bend. It would have been nice if the sides of the external battery had a bit more of wrap around the controllers to prevent you from being able to pull the switch out from the front.

Love this case for my grandson. Bought the case in Oct and about March or April the battery stopped working. I contacted the seller, and they were awesome after sending them photos and video of the unit they replaced the unit. Very pleased with the quality of the case and very thankful for the communication from the seller. Will buy again.