Rockford FosgatePrime R1T-S 1" Tweeter Kit (Pair)

I have a Honda Fit which needed an upgrade in the stock speakers. With new Rockford 6” door speaker and a powered MTX tube sub I thought I was done. On a whim I decided to replace the front tweeters not expecting much change. I was way wrong. These tweeters expanded the sound stage, they are present without over saturation. I drive a minimum of an hour and half, five days a week to work, this car is my commuter. Regardless of the type of music played these speakers enhance and blend the sound stage without over powering, and yet are still distinctive.

I replaced the stock tweeters in a Jeep JK. They are larger than the tombstone holders so you have to trim them. I used a Dremel but do it slowly. Trim some and then try to insert them. Repeat until they snap in. Sounds good.

Was looking at the Quadratec $140 speakers because my buddy threw them in his JK but I gambled on these Rockfords. They are MUCH better than the Quadratec’s! No need for any power tools, I trimmed the tombstone with a blade and the tweeter has a snug fit. Don’t be intimidated because it’s not plug and play simply slice the wires and your JK will sound AMAZING!

Replacement for the stock tombstone tweeters in a JK, I was hesitant because you DO HAVE TO trim the hole to get these to pop in but looking at the price of plug and plays from that jeep place compared to new tombstones if I messes up seemed like a no brainer. Shaved about 1/8-1/4 all around with a box knife and although it didn't look pretty these snapped in super tight and hid everything and look great. As for the sound, I didn't notice much of a change at all with the factory head unit but a new 45 rms amped head unit made them scream. They were actually super bright so had to tone all that down but now you can actually tell the system has tweeters and the highs sound great. So for the price I'd definitely recommend them.

Good quality

These tweeters absolutely brought my cars sound system to life with incredible highs in any music I listen to. Very very crisp and clear sounding, and their build quality is great they don’t feel cheap in any way.

Installation was straightforward with a little trimming of the tombstone units. Get a good connection with splicing the correct wires and these things will change the whole dynamic for your car audio system!Make sure to take your time on the trimming and not make the hole too big to ensure a snug fit!

Stumbled across these on a YouTube video. Had changed out the stereo in my 2016 Impala Limited, and discovered these would pretty much just snap into the factory brackets in my windshield pillar trim. I did put a dollop of hot glue on each mounting clip for extra security. They really made a difference in the top end. They are being powered by a 45 Watt Kenwood unit.